- Joined
- Oct 11, 2022
- Messages
- 369
I hate electrical…
I’m planning to install this Painless battery disconnect: https://www.summitracing.com/parts/prf-30206
I want it mainly to de-energize the main harness while it’s parked to avoid any surprise shorts or anything when I’m not in the Bronco. I’m not concerned about breaking the path to the starter directly and not as first line theft deterrent.
I have a high torque starter that is wired by putting the battery and starter cable on the same side of the starter solenoid and then the signal wire on the switched side.
The disconnect instructions place it between the battery and starter solenoid, but I don’t want to put the entire starter load through the disconnect if I can help it.
So I’m thinking of the following:
Starter solenoid has battery and starter cables on the one side, then run another cable from that same side through a mega fuse to the disconnect. Then put the harness on the other side of the disconnect. That way the harness is disconnected and the Bronco wouldn’t start because the ignition switch doesn’t have power, but the starter load is straight through.
My first question is: does this work?
Second: where should I put the alternator wire? Do I leave it on the powered side of the starter solenoid with the battery/starter cable? Or should it go on the switched side of the disconnect with the harness?
I want to make sure I wouldn’t have an issue with the alternator if the power is cut via the disconnect while the engine is running (either accidentally or in an emergency), not sure if that’s possible.
Third, can someone confirm the thicker black wire below (with the fuse) is the alternator and the yellow wire is the harness? The black wire branches off from the bundle coming from the alternator, but I didn’t want to just assume in case there was something I don’t understand.
Lastly, can someone confirm the gauge of the yellow wire? I want to crimp a new ring terminal on there.
I’m planning to install this Painless battery disconnect: https://www.summitracing.com/parts/prf-30206
I want it mainly to de-energize the main harness while it’s parked to avoid any surprise shorts or anything when I’m not in the Bronco. I’m not concerned about breaking the path to the starter directly and not as first line theft deterrent.
I have a high torque starter that is wired by putting the battery and starter cable on the same side of the starter solenoid and then the signal wire on the switched side.
The disconnect instructions place it between the battery and starter solenoid, but I don’t want to put the entire starter load through the disconnect if I can help it.
So I’m thinking of the following:
Starter solenoid has battery and starter cables on the one side, then run another cable from that same side through a mega fuse to the disconnect. Then put the harness on the other side of the disconnect. That way the harness is disconnected and the Bronco wouldn’t start because the ignition switch doesn’t have power, but the starter load is straight through.
My first question is: does this work?
Second: where should I put the alternator wire? Do I leave it on the powered side of the starter solenoid with the battery/starter cable? Or should it go on the switched side of the disconnect with the harness?
I want to make sure I wouldn’t have an issue with the alternator if the power is cut via the disconnect while the engine is running (either accidentally or in an emergency), not sure if that’s possible.
Third, can someone confirm the thicker black wire below (with the fuse) is the alternator and the yellow wire is the harness? The black wire branches off from the bundle coming from the alternator, but I didn’t want to just assume in case there was something I don’t understand.
Lastly, can someone confirm the gauge of the yellow wire? I want to crimp a new ring terminal on there.
Last edited:











