The shop that did my short block gave me this balance sheet and said it would be needed if ever working on the rotating assembly.
I have no idea what these figures mean...curious if someone could explain.
The numbers are weights of internal engine parts in grams. Pistons, rings, etc. should be self explanatory.
Rods are measured at each end seperatly
oil allowance is an educated guess on how much oil is stuck to the parts as the engine is running.
The 50% balance factor is half of the recricapating weight (piston, rings, pin, small end of the rod).
Add that to the weight of the big end of the rod and the bearings. Then double that since there are 2 rods on each journal.
Then then clamp that much weight onto the crankshaft and stick it on a very fancy balancer like what a tire shop uses to balance your tires. Then they do what they need to in order for it to spin without shaking.
Important note, your engine was balanced using a 50 oz-in flexplate and damper. You must use flexplate and damper from a late model 5.0 engine, not the early 302 or 351. Good thing is you can use an explorer front drive without having to rebalance the damper. Bad thing is you can't use your original flexplate/flywheel/damper parts. That may become an issue when putting all the parts on the engine and getting it in the rig.