Search results

I haven't checked for a few years, the last I checked this manufacturer had terrible reviews. The reviews were centered around warranty work. He was in the Bitterroot valley at the time and I had stopped in and looked at his trailers at one point. Don't know if anything has changed since.

Been down the road for years and a bunch of miles with sundowner trailers. In fact the parking lots were full of them and other manufacturers. As yeller said stress cracks are common, especially at the door hinges. The stock trailers hauling cattle had floor support issues. Horse trailers...

Is the distributor drive gear the correct one for your camshaft?

Op hasn't been back since posting so I'm not sure if this is a waste of time. What does the remote say about engine temperature? How responsive is the O2 sensor for both RPM and engine temperature? Hook up a vacuum gauge and take readings at idle, 1500, 2000 RPM. Hook up your timing...

Hopefully you don't mind me adding on to your thread, if so I will delete. One of my nieces sent me this today. She lives in St George, UT.

Been proven consistently every time you drive down a dirt road and your back window is covered in dust. Drive the same road with the same vehicle and a spoiler at the top with a slight curve directing the air flow down across the back window.

https://classicbroncos.com/forums/account/upgrades

Is the vibration in the front or rear? Basic checks that need to be verified, is it in 2h, hubs unlocked? Do the front axles turn when driving. What tires, how long on the vehicle, when were they last balanced? Remove front drive line and drive. Do you still have a CV rear drive...

That one gives you the option of a heater!! No need to pull for heat. Ntsqd, same as you.

You could take the nuclear option and go the RV route.

Can you give more information on how you tested to determine it is the tie rod end binding versus ball joints?

When you say steering is new, which parts exactly. Did you undo your linkage on both sides and turn the spindles individually? Did you or someone else install new ball joints?

Basically what inboard motor boats use to vent the engine compartment. Should reasonable easy to setup your own.

This is very disappointing to hear. Anyone can be a good seller when things are going well, it's when things go bad that you really find out who you are dealing with. Anytime metal has gone through a engine the need to properly flush out EVERY oil passage is critical to the success of the...

No, send them to me and I can safely dispose of them for you. 😊

Uhh, you going to keep it a secret or share the seller. 😀

My guess is a old style footman loop type of bracket. Used to tie down something owner specific. Could be a high lift or shovel, Pulaski etc. The wear mark in the center was probably from whatever was strapped there and could eliminate a couple things I mentioned. Canoe tie down isn't very...

I appreciate you sharing your experience. This is something I've been considering for awhile. I know some will say to go with the 6R but I have the 4R and the computer to run it with the explorer motor. Yeah I know, I can't adjust the shift points the same. I would love to find a atlas...

When you say leaking by the hub, are you talking about the locking hub. If so then it going to be wheel bearing grease in that area. If not and by the inner C you will need to disassemble to pull the axle