Search results

I am interested in the doors. Please send pics, thanks.

Seems like I have done something wrong. I am installing a 351 in my 77 Bronco. Ordered new motor mounts. When I went to install the motor it doesn't seem to set square in the frame, is this normal?

I am switching out my 302 for a 351. I thought I have read that the engine does not set level in the frame, but actually tilts down a little in the back. Can anyone confirm this and if so, how much lower in the back than the front?

Could someone tell me the minimum suspension lift required to run 35" tires without cutting the front fenders? I will be using a 1" body lift. This will be a daily driver so would a 10 or 11 leaf system give a btter ride quality over the standard leaf pack?

relace quarter panel When replacing a partial quarter panel, since I am not going to take out all the spot welds, should I butt the new panel up against the bottom of the upper quarter or stop it a couple of inches from the top and either crimp the panel with a flange or overlay it and fill...

I am in on the Baumannator mass buy. Thanks

PB blaster I will try the PB Blaster soak tonight and see if I can pull it with the slide hammer tomorrow.

Need a few suggestions. I am trying to get the rear axles out. The driver side came out easy, but the passenger side won't budge. I have tried turning the drum around and using it like a slide hammer, tried a real slide hammer and no luck. Seems to have come part way out, but just can't get it...

original radiator I am interested.

Have they been sold yet?

I think your right, rear drive shaft would be too short.

Has anyone installed Dear Vendors over/under unit? I know it will not work in 4 wheel drive, but seems like a nice feature for street cruising.

I am looking for an NP205 and a 351W.

Do I understand it correctly, if I use a 2000 Explorer transmission from an AWD, all I need is the ZFadpater to use my Dana 20? No other adapters needed? Just add a Baumann controller and a TVS.

If still for sale, please email contact info to laen46@yahoo.com, thanks.

Where can I get step bars for the sides of my bronco?

In Charlotte I am in Charlotte and interested. Please send pics. I can pick up at anytime.

I have just completed my restoration and have only one problem. The left front tire barely hits the inner wheel well when turning hard to the right than back to the left. How can I raise the left front just 1/2 inch. Is this possible without putting on new front springs?