Search results

thanks I think I'll give it a try.

Is it possible to change oil pan gaskets without raising the engine. Mine leaks a little but not enough to bother with raising the engine.

My bronco makes a squeeling noise while I'm excelerating. Then kind of a rattleling noise when I let off the peddle. It still shifts fine but noise has me worried. It only does it while driving. Any ideas what is causing the noise? Bad cv joint and drive shaft was not sliding freely. thanks for...

thank for the help I have seen many I liked but was hoping someone had a blueprint or something. I guess I will try and make a template before I start bending.

thanks for the info

I have a 75 with 3spd trans. Under hard acceleration from stop it has bad wheel hop, and wants to pop out of reverse. Any solutions?

Does anyone have measurements for full cage or some type of blue print to fab from scratch???

if I was going to put a chevy motor in one I would also add a rear bumper from a new S-10. They are heated so your hands don't get cold when you have to push it.

thanks I never would of guessed motor oil in the transfer case.

If you have a summit or jegs catelog the torker 2 intake is a square and the peformer is a spread.

What type gear oil should I use with the factory limited slip rear end? Can I use the same oil in the front and transfer caseas well.

Thanks for the link. Mine is definetly in the wrong place.

I have an old Kayline soft top that I took off 2 years ago. I got it all back together but the frame over the doors don't look right. Does any one know where the vertical rod goes at on the bed side? How close to the door post?

I agree with them

909 off of I 75 Many people from OH go there

thanks I'll check Napa

I'm runnin turbo mufflers. It sounds pretty good not too loud but a good deep sound

I just put a set of heddmans on my 302. The headers work well but you can't get a plug socket on some of the spark plugs with the hedders tight. I had to loosen the headers to tighten the plugs. If I would have known this before I mounted them I would have removed some of the meat around the...

I was wondering if ebs came with a short water pump on the 302 motor. My 74 came with a jasper crate motor so I don't know what it had originally. I was looking at someones bronco at a truck show and noticed they had way more room between the fan and the radiator. Mine only has 3/8" of clearance.

I bought the heddman from summit and have no problems