• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

3 and 4 wire connectors

bludorbronc

Sr. Member
Joined
Apr 19, 2006
Messages
653
i am working on a 74 bronco wiring problem. on the firewall next to where the throttle linkage comes thru the firewall, i have a flat 3 wire connector and a square 4 wire connector, the 3 goes toward engine compartment and the 4 goes under the center of the truck, can the connectors be bought new. thanks
 

yjzonie

Sr. Member
Joined
Jun 18, 2008
Messages
671
Loc.
Scottsdale, AZ
3 wire is for oil pressure, engine temp and 12 volt coil power. 4 wire is for nuetral safety switch on the tranmission.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
The neutral safety/reverse light connector is not available anymore. You can use two 2-pin flat connectors to attach to the original 4-pin however. Napa's got 'em.
 
OP
OP
B

bludorbronc

Sr. Member
Joined
Apr 19, 2006
Messages
653
thanks for your help. i think the red going to the coil melted, i need to make sure my grounds are good. i run a ballist resister so it should not have been carrying to much ampereage.
 
Top