• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

302 Head / Valve spring issues.

welndmn

Bronco Guru
Joined
Nov 12, 2001
Messages
2,112
Trying to replace my valve seals but I can't get the lock off.
As you see in the pics, its 2 peice I think?
You can see the wedge shaped locked still inside a cylinder holder.
You can see the valve spring is compressed, yet, because the lock is stuck inside this other peice, I can get the lock off.
Any ideas?
I tried compressing the spring at that "sleve" part where the lock is stuck on and it did not budge.
So how the heck do I get the lock out?
IMG_0035.jpg

IMG_0036.jpg
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
There just stuck together. Give the retainer a sharp rap with something and it will fall down.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
X2 most heads I've torn down had that issue a few taps with a hammer will loosen it up.
While it wont prevent the locks from sticking you might consider getting some one piece valve retainers. They are better than those 2 piece type you have and will give you a bigger target for the hammer if you ever have to tear it down again.
 
Top