• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

4x4x2 Porting Location

BruiserOutdoors

Bronco Guru
Joined
Aug 22, 2013
Messages
1,030
Had a 4x4x2 box built and ported by WTO. After further consideration, I am wondering if the ported location will be interfered with by the inner fenders/sheetmetal. Seems rather close to the body mount as it is.


Thoughts?


20230712_070202.jpg
20230712_070210.jpg
20230712_070219.jpg
 

ssray

Contributor
Sr. Member
Joined
Apr 19, 2010
Messages
922
Loc.
South Central NE
I know you can get brass fittings in a 90 that wouldn’t stick out so far but I’ve seen cautions about using sharp angle connectors in PS. Not sure about a pressure rating as I just use them on airlines. They may have 45 degree fittings that might not be quite as severe though. Shoot, only took a minute to find these.

 
Last edited:
OP
OP
BruiserOutdoors

BruiserOutdoors

Bronco Guru
Joined
Aug 22, 2013
Messages
1,030
I know you can get brass fittings in a 90 that wouldn’t stick out so far but I’ve seen cautions about using sharp angle connectors in PS. Not sure about a pressure rating as I just use them on airlines. They may have 45 degree fittings that might not be quite as severe though.
ram assists generally have 90* fittings, don't they?
 

ssray

Contributor
Sr. Member
Joined
Apr 19, 2010
Messages
922
Loc.
South Central NE
ram assists generally have 90* fittings, don't they?
Yes, I know I’ve seen a lot of them being a farmer. The post I remember might of been related to fittings on hose ends used for the PS and hydra-boost. Maybe some one else will remember the post. Might make a difference if the pump isn’t up to the task.
 
Top