Ok so from my thread last week I have picked up a 95 mustang Gt 5.0 engine
Its been converted to carb, and I will be getting the complete engine including water pump. but no pulleys .
My question is what do I do about the front pulleys?
1- can I use anything from my 75 motor?
2- what do i do about the water pump use new one or convert to old one?
3- looking at 5.0 explorer serp setup but have called a few wrecking yards and there are none to be found within a 100miles ( lots of 4.0l )
4-should I look for a 95 mustang serp setup? it may be easier to find . but from what I have read the fan may hit the rad?
Its been converted to carb, and I will be getting the complete engine including water pump. but no pulleys .
My question is what do I do about the front pulleys?
1- can I use anything from my 75 motor?
2- what do i do about the water pump use new one or convert to old one?
3- looking at 5.0 explorer serp setup but have called a few wrecking yards and there are none to be found within a 100miles ( lots of 4.0l )
4-should I look for a 95 mustang serp setup? it may be easier to find . but from what I have read the fan may hit the rad?











