• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

95 5.0 pulleys

croft75

Sr. Member
Joined
Feb 9, 2007
Messages
781
Ok so from my thread last week I have picked up a 95 mustang Gt 5.0 engine
Its been converted to carb, and I will be getting the complete engine including water pump. but no pulleys .

My question is what do I do about the front pulleys?

1- can I use anything from my 75 motor?

2- what do i do about the water pump use new one or convert to old one?

3- looking at 5.0 explorer serp setup but have called a few wrecking yards and there are none to be found within a 100miles ( lots of 4.0l )

4-should I look for a 95 mustang serp setup? it may be easier to find . but from what I have read the fan may hit the rad?
 

duffymahoney

Contributor
Bronco Guru
Joined
Apr 26, 2015
Messages
2,734
Hit up craigslist, find a explorer that doesn't run or is beat up. There are some for sale in the 300-500 range in my area with the 5.0. You can pull what you need and scrap the rest.
 

mudstud

Contributor
Bronco Bonehead
Joined
May 19, 2005
Messages
1,517
Loc.
Excel
I have a 95 serp set-up and it works fine. I believe that the 95 timing cover has the same depth as the explorer.
 

Timmy390

Contributor
Bronco Guru
Joined
Jan 1, 2011
Messages
5,948
Loc.
Conway, AR
The 95 was electric fan only so with the 95 pulleys you're going to have to buy an electric fan (not sure which on you can use with that setup) and possibly move the radiator forward (reverse the top mounts to the outside of the core support). That's going to cost you some bucks getting that setup.

The 95 timing cover does not have the provision for a fuel pump and I'm not sure if a fuel pump cam eccentric will fit on the cam (I've heard EFI engines use a thick cam retainer plate with longer bolts than the carb'd engines but I don't know first hand). If one will fit you could use the front dress off the 75 302 BUT the 95 heads might not have the correct bolt size holes needed. If the cam can't accept the fuel pump cam eccentric you have to fun an 12 volt external fuel pump.

Tim
 

mudstud

Contributor
Bronco Bonehead
Joined
May 19, 2005
Messages
1,517
Loc.
Excel
Timmy390 is right about the fuel pump but I was running an electric pump before the conversion. I am running a flex fan on this setup. I do not have an electric fan. I seem to remember putting a explorer water pump on it.
 

rguest3

Bronco Guru
Joined
Dec 13, 2012
Messages
3,780
94-95 Mustang Serpentine system has the same depth as an Explorer. Almost identical water pump as well.

croft75 - PM me. I have both complete set ups in my shop.

Long way (expensive) to ship to Canada though.
 
Top