Here's mine...
I'm very happy with the articulation. Successfully ran the Rubicon a few years ago and we're going again this summer. It's fun to watch the reaction of the Jeepers when I lean away from squeeze rock on the way up Cadillac Hill.
The bags are by Goodyear. Here's a listing for them (I've made an effort to find places where I'll continue to be able to source them). They're rolling lobe as opposed to the single or double convolute that most equate airbag suspension with.
http://www.sdtrucksprings.com/index.php?main_page=product_info&products_id=16266
As you can see by the listing, they are about 12" travel and, in my geometry, I've got them choked up a little. That way I get a lot more than 12" of wheel travel in an articulation situation.
Broncobowsher is absolutely correct that the bell shape of the "piston" that the bag rolls over creates an extremely progressive spring rate. The result is a lot of stored energy when you hit a big bump and compress deep in to the travel. I was at Pismo Beach several years ago and was coming off of a dune where the transition from the dune face to the flat was very abrupt. The suspension compressed and then rebounded so dramatically that the Bronco actually bounced off the ground! I could see it clearly in my tracks where I paced off about a 10 foot gap. That was when I decided to make my own bag pistons with no bell shape at the bottom.
I then added some Light racing bump cans and they've really proven to be a game changer. I can now hit big bumps without fear of bouncing off the ground and losing control.
I've installed the straight rate pistons and bump cans in the front but have yet to do the same to the rear which still includes traditional rubber bump stops.
I've also installed a front sway bar since the design of my front end has very little roll stiffness. The bar is from a circa 1997 or so Dodge 1500 4x4.
I plan to install a very light sway bar in the rear to get the limit handling that I want out of it. I'll do this at the same time as the rear bump can and straight rate bag piston installation. Then I'll be able to remove the rubber bump stops as well.
The bags seem to be pretty reliable as long as you don't overcompress them. Due to small air leaks here and there, my Bronco eventually loses pressure if parked for more than a few days and, before I installed the rubber bump stops in the rear and the bump cans in the front, the bags were definitely overcompressed when the system lost pressure.
These bags would probably not work without going to full-width axles unless you get really inventive with your installation.
There really isn't a single thing that I dislike about the air bag suspension. It was a lot of work but I've ended up with better ride quality and better performance in every situation I've had it in. I've even loaded it up pretty heavily and the bags have proven to be quite useful. The rear Protofab bumper is pretty heavy to begin with and I had to use a fairly long 12" extension to get clearance between the bike in the following picture and the racks. But, with the bags, I just had to add more air pressure (maybe 40 psi rather than the usual 30) to bring it back to level.
As far as controls go, I use four industrial 5-way pneumatic valves typically used for controlling air cylinders. The valves are located between the front seats and I have four gages indicating the pressure in each bag. The air source is a York compressor driven off of the engine.
A future project will be the installation of an Aire Jax manual air valve set. I've had to rebuild the industrial valves and it was a pain. Hoping the Aire Jax will be more serviceable.
http://www.airejax.com/four-play/