• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

All new braking system

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
I have replaced every part of the braking system on my 67 and added Chevy Disk brakes in the process. Nothing hasn't been replaced throughout. I just bench bled the master cylincer and wondered it there were any special considerations I should beware of when I go to bleed this thing. All the lines will be full of air, so I assume this will be a chore to bleed. Should I just follow the basic farthest wheel first concept and if so, will that pull fluid to all portions of the system? I did a search, but didn't come up with anything just like this.
 

br0nc0xrapt0r

Loves pickles
Joined
Sep 28, 2007
Messages
5,439
When I did this I just opened up both rears and hooked up hoses to drain the fluid and pumped-filled-pumped-filled-pumped until it was good.
 

bknbronco

Bronco Guru
Joined
Jan 17, 2011
Messages
4,388
Loc.
North Metro, MN
When i bled my entire all new system it didnt take that long. Them tiny hoses dont really hold that much brake fluid. 1 large bottle from walmart was way more than enough. I think i bled the system starting in the rear then moved to the front. Then went back again just to make sure. I had a problem with a few of the bleeder screws sucking air through the threads, and making me think there was still air in the system. I wish they would all come with that blue gunk on the threads to seal them. I think i ended up wraping them with thread tape a bit. If you can find new bleeders with the thread seal on them then replace them now. May save you some frustration down the line. But either way mine bled fine and didnt take long or that much fluid.

Just watch the fluid level closly so you dont drain the resevore or you have to start over. And dont pump without the cap on or it will squirt when you release the pedal i think?
 

73azbronco

Contributor
Bronco Guru
Joined
Nov 11, 2007
Messages
8,782
I would after bleeding everything, let it sit a day and do it again.
 
Top