another "C" bushing post

[jasondemitri]

i pulled my front axle and checked my frony c bushings (because my caster was 5 degrees off) and i found that all four bushings are marked "rear bottom". i figure that if all four are marked rear bottom, then the front would have to be upside down. my question is "are the duff 6.25 offset marked rear bottom?" or are the bushings also marked front ....and i just have two of the wrong bushungs? anyway it turns out, im ordering new 6.25 bushings from duffs tomorrow (one is not readable) so i will have no doubts as to which way they go. if they are all four marked rear bottom, then at least one side was wrong. hope this makes sense
jason

 

[zeusakira]

I had that same question before.If I remember right they are the coorect bushings. All you have to do is flip the other ones for the front so that it says rear bottom on the top which puts the outside geometry of the bushings back to factory but the inside angle that holds axle is where they difference is. Don't forget to take a knife and cut away the little tip that sticks out where they injected the mold to make theese. It looks like it belongs there but it doesn't.