- Joined
- Nov 28, 2011
- Messages
- 842
So I got my new Wildhorses D44 axle shafts today. I have a narrowed HP D44 out of a big Bronco. I had to get a driver side inner out of the big Bronco and a passenger side inner out of the EB.
The driver side length looks good to me. It seats all the way and is flush on the inside of the carrier. But, the passenger side bottoms out and is still sticking out of the housing by about 5/8”
I measured the length and it is in fact the EB length of 27 15/16”. So my guess is whoever narrowed this housing went a little overboard?
How much spline do I need left to engage with the carrier? The splines are right at 2 3/4”. Is it as simple as cutting 5/8” off of the end (making sure not to mess up the splines) and then call it a day? This would leave me with roughly 2 1/8” left of splined end, call it 2” after waste.
The driver side length looks good to me. It seats all the way and is flush on the inside of the carrier. But, the passenger side bottoms out and is still sticking out of the housing by about 5/8”
I measured the length and it is in fact the EB length of 27 15/16”. So my guess is whoever narrowed this housing went a little overboard?
How much spline do I need left to engage with the carrier? The splines are right at 2 3/4”. Is it as simple as cutting 5/8” off of the end (making sure not to mess up the splines) and then call it a day? This would leave me with roughly 2 1/8” left of splined end, call it 2” after waste.











