• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Banjo Bolt Size

bronccar

Sr. Member
Joined
Feb 21, 2005
Messages
811
What size are the banjo bolts in a 76 D44? I'm not having any luck finding them via a vehicle specific search.

I came up with 7/16-20x1-1/16 from a thread here but wanted to be sure.

Need washers too

Thanks!
 

ntsqd

heratic car camper
Joined
Jan 30, 2005
Messages
5,970
Loc.
Upper SoKA
Can't help with the thread size. Were they GM calipers I'd say that's one of the two possibles.

Do you have the old washers? If they're not too gouged up they can be re-used with a simple trick. Make a simple hanger out of mechanic's/baling wire and grab a propane torch and a Red Solo Cup filled with water. Hang a washer on the wire and heat until you see some blue-green color in the torch's flame and immediately drop it into the water. Repeat with all of the washers. Unlike with steel, doing this with copper anneals it and make it dead soft again.
 

Apogee

Contributor
Bronco Guru
Joined
Nov 26, 2005
Messages
6,348
Loc.
Tangent, OR
Ford EB/F150 calipers have a 3/8-24 inlet port on the calipers. The larger bore T-bird/LTD calipers use a 7/16-24 and GM calipers (D52) use a 7/16-20 banjo bolt.
 
OP
OP
bronccar

bronccar

Sr. Member
Joined
Feb 21, 2005
Messages
811
It's an EB D44

I was fixing to go pick up a Dorman 3/8 - 24 lol

Thanks a bunch - great info.
 
Top