• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Cam dowel pin

FASTERDAMITT

Sr. Member
Joined
Nov 20, 2006
Messages
806
Loc.
Oceanside
I was installing a new Comp cam and they forgot the dowel pin. I have one laying around that slides in but does not need tapped with a hammer to get in. Will this work or does it have to be press fit? By the way, the cam bolt washer keeps the dowel pin from conung out. 94 5.0 block

Thanks
 

Rondo Talbot

New Member
Joined
Sep 2, 2007
Messages
1
The cam dowel pin that I used in my custom ground roller cam came out of my E303 roller cam. I installed it (tapped it in with a hammer) in the end of the cam. Originally the pin was in a plastic bag in the Motorsport box. It was not a press fit. There was no play but it was certainly not a press fit. It could be removed with pliers.

As you mentioned the dowel cannot go anywhere as it is held in place by the cam bolt washer. Its job is to transfer power from the timing chain gear to the cam. As long as those parts mate up without rotational slop, what could be the problem?

By the way I think there were 2 different length dowel pins supplied with my Motorsport cam to cover different timing chain gear designs. I used the pin that came close to flush with the face of the timing chain gear.
 

wildbill

Old Bronco Guy
Joined
Jun 29, 2001
Messages
6,890
:p :p :p If it will just slip in DON'T use it they need to be taped in or can work out and you can lose fuel pump and the valves can get bent. You should be able to find one at a parts store or engine shop good luck and have fun.:cool: :cool: :cool: Bill :D %) :eek:
 
OP
OP
FASTERDAMITT

FASTERDAMITT

Sr. Member
Joined
Nov 20, 2006
Messages
806
Loc.
Oceanside
Hmmmm... Mine will slide in easilly, but can't come out without removing the cam bolt washer.

Check out what Crane cams says here:

4) Broken dowel pins or keys.
The dowel pin or Woodruff key does not drive the cam; the torque of the timing gear bolt, or bolts, against the front of the cam drives the cam. Some reasons for the dowel pin or key failing are: Bolts not being torqued to correct specs; Incorrect bolts of a lower grade being used; Stretching and losing torque; Not using the correct hardened washer that may distort and cause torque of the bolt to change; LocTite not being used; Or some interference with the cam and lifters or connecting rods causing the cam to stop rotation.
 
Top