I'm installing a new tie rod and adjustable drag link. I recently installed a Dana 44 to replace the old 30. I noticed that the axle is about 1" to the passenger's side; springs seem to "drift", and the tires are unequal in line with the body.
My first inclination is to remove the trac bar (i have a new adjustable to replace), and rig a come-along to pull the axle into position while raised; adjust the new trac bar to length and install.
Any thoughts on this procedure, or a better way?
Many thanks in advance.
My first inclination is to remove the trac bar (i have a new adjustable to replace), and rig a come-along to pull the axle into position while raised; adjust the new trac bar to length and install.
Any thoughts on this procedure, or a better way?
Many thanks in advance.











