KyleQ
Bronco Guru
- Joined
- Apr 24, 2008
- Messages
- 5,480
I've got a tab style bell currently in the truck and I've got an aluminum hydro bell in the barn.
I'm at a loss on to what happened to my clutch this weekend - I've got all of the clutch brackets properly mounted, I've even got the EFI clutch mount bracket installed. It's very solid -
I can adjust the linkage multiple times and it still goes to the floor. It seems to want to go back and up at an angle and its like its falling off the TOB or something. If I pull down on the fork and push back it seems like its there, but it doesn't even work once after I put it back together.
I ran into this before - but I replaced the TOB and I was good. I'm curious - what all does the fork pivot off of? I can nearly pull the clutch fork out of the side of the transmission right now. I understand the end clips onto the TOB and the clip mid way on the arm goes through the tab on the bell housing, but there is a ball with tabs over it - what does that pivot off of?
I'm going to convert over to a hydraulic setup - I'm going to run the How slave and Wilwood master and fab a mount off the transmission so it isn't a waste of time. I want to figure out why the clutch fork is doing what it is doing so it doesn't happen on my next trip out. Anyone run into this?
I'll take some pics and video tomorrow-
Thanks-
Kyle
I'm at a loss on to what happened to my clutch this weekend - I've got all of the clutch brackets properly mounted, I've even got the EFI clutch mount bracket installed. It's very solid -
I can adjust the linkage multiple times and it still goes to the floor. It seems to want to go back and up at an angle and its like its falling off the TOB or something. If I pull down on the fork and push back it seems like its there, but it doesn't even work once after I put it back together.
I ran into this before - but I replaced the TOB and I was good. I'm curious - what all does the fork pivot off of? I can nearly pull the clutch fork out of the side of the transmission right now. I understand the end clips onto the TOB and the clip mid way on the arm goes through the tab on the bell housing, but there is a ball with tabs over it - what does that pivot off of?
I'm going to convert over to a hydraulic setup - I'm going to run the How slave and Wilwood master and fab a mount off the transmission so it isn't a waste of time. I want to figure out why the clutch fork is doing what it is doing so it doesn't happen on my next trip out. Anyone run into this?
I'll take some pics and video tomorrow-
Thanks-
Kyle
Last edited:











