• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Dana 30 Help Needed

TBS-POPS

Bronco Guru
Joined
Jun 16, 2007
Messages
1,388
Loc.
valley springs, ca
Camber adjusted with spindle wedges and caster with c-bushings. Did you replace the king pins yet??? Best way to adjust a 30 is to replace it with a 44.....
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
Caster is done with C-bushings where the axle is held to the radius arms
Camber is done with shims between the knuckle and the spindle.
Since it is a kingpinned D30 the ecentric that other people will tell you to use at the ball joint won't work (you don't have a ball joint with the kingpins).
 

feitctaj

FNG
Joined
May 3, 2003
Messages
4,319
Loc.
Group W Bench
You bought a Bronco and did not buy a book? even the cheepy chiltons have these diagrams. THe best diagrams are in the Ford Manuals
 
OP
OP
Explorer

Explorer

Bronco Guru
Joined
Mar 2, 2008
Messages
4,390
Loc.
Raphine, Virginia
You bought a Bronco and did not buy a book? even the cheepy chiltons have these diagrams. THe best diagrams are in the Ford Manuals

This is my fourth Bronco build, but the first with a Dana 30 and the Chiltons books only go back to 73. I have a complete set of Ford shop manuals for a 76 but no help there. This early 66 has a lot of things I'm not used to and year specific including brakes w/no self adjusters. Another learning proccess.
 

deltarat

Bronco Guru
Joined
Jul 12, 2006
Messages
3,371
Loc.
Drew,Ms
LMC truck used to have offset kingpins. I haven't used them or know if they still have them.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
I just checked the Ingall's Alignment Products website for those not long ago, but could only find the ones for the Dana 60 kingpins. They're a great idea, and I have them on my F350, so if you can find them from LMC, or anywhere else, that would be a good find.

Paul
 

feitctaj

FNG
Joined
May 3, 2003
Messages
4,319
Loc.
Group W Bench
This is my fourth Bronco build, but the first with a Dana 30 and the Chiltons books only go back to 73. I have a complete set of Ford shop manuals for a 76 but no help there. This early 66 has a lot of things I'm not used to and year specific including brakes w/no self adjusters. Another learning proccess.

I have three Chiltons that start in 66 and they even give the preload for the Kingpins, an exploded diagram is missing the fine stuff
 
Top