• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Dana 30 Torque Bearing Preload

jrcBronco

Contributor
New Member
Joined
Jul 19, 2012
Messages
25
Loc.
Richmond, Virginia
I am trying to determine the correct method for setting the torque bearing preload on a Dana 30 front axle. The manual states “starting” torque bearing preload is the correct value (9-16 ft lbs). See a screen shot of the shop manual below.

Does “starting“ mean: torque reading the exact moment the steering knuckle first begins to move?

I do get higher readings during the torque wrench/knuckle travel especially as I turn the torque wrench and the knuckle gets closer to the knuckle turn stop bolt(full turn). I get around 11ft lbs once it starts to move but tends to increase to about 16-18ft lbs during the torque wrench travel.

Any thoughts?

Thanks
Jeff


IMG_1948.jpeg
 
Top