Im trying to finish up the installation of my narrowed high pinion out of a 79 Bronco going in my 75. I added Reid knuckles, the passenger side was shortened 6 inches, i'm running 76 Bronco dana 44 spindles and caliper brackets. While finishing up the driver side install, I was putting the snap ring on and it wont seat in the groove on the axle shaft, it looks as if the axle needs to be pulled out about 1/16 of an inch, or the spindle needs to shortned 1/16 of an inch, i'm adding picks, but they are pretty crappy. Any ideas on what to do to slove this problem. The axle moves freely when turning the pinion yoke. Thanks.











