LA Door (bottom portion only)

[lsukevinc]

The only remaining rust spot on my 76 left to repair is the bottom of my driver's door. Does anyone have a section they could cut off of a door they are not using and ship it to me? I am willing to pay for the material and shipping. The rust is at the 90 degree edge facing inside with bronco. It is a little hard to see in the picture below, but I think you will se what I am talking about. Or would I be better trying to bend a piece of sheet metal and making a patch panel myself?

 

[BoureeOne]

I might have a door you can have. Cant remember if I threw them out or not. I will let you know.

 

[lsukevinc]

I might have a door you can have. Cant remember if I threw them out or not. I will let you know.

ok cool, Let me know if you do.

 

[Mattco]

https://www.npdlink.com/store/products/bronco_repair_panel_door_lower_inside-130867-80740.html

If you don't find one, I think this is what you are looking for

 

[lsukevinc]

https://www.npdlink.com/store/products/bronco_repair_panel_door_lower_inside-130867-80740.html

If you don't find one, I think this is what you are looking for

that is the first one I have seen produced. Thank you.

 

[Mattco]

That place has a lot of oddball pieces of body panels. Not even sure where I found that site

 

[OB Bronco]

See if this will work. http://dennis-carpenter.com/door-bottom-panel/p/C6TZ-9720131/

 

[lsukevinc]

See if this will work. http://dennis-carpenter.com/door-bottom-panel/p/C6TZ-9720131/

that will probably work too, thanks