I have the FiTech 400 and had a fuel commander installed. The FCC uses a variable input signal to help control fuel pressure.
I was not aware that FiTech controlled any pumps in this way. Are you using an original style FCC, or the newer replacement?
Guess I'll have to read up on it, because I thought it was a simple internal pressure regulated valve that simply dumped excess fuel back into the FCC reservoir as the correct pressure was achieved. Then working pressure for the injectors was regulated at the throttle body's internal regulator.
I am installing a 23 gallon tank with a high pressure pump installed and am planning to use an electric pump to transfer fuel out of the side tank to the rear. I'll switch that separate, but I'm thinking I would want to pull juice for that pump after the inertia switch just like the rear high pressure pump.
So you'd be running three pumps off of the inertia switch? Or are you getting rid of the FCC altogether? Sounds like you're keeping it, but that would not really make sense, so can we assume you're tossing out the FCC in favor of the new in-tank pump?
I'm not sure if the switch has a load limit, but I'd check into that before running two, or especially three pumps.
Of course, even with the FCC intact only two would be running at a time normally, but in case you decided to transfer fuel while driving that would add the additional pump.
Otherwise yes, I would agree that any pump should be powered through the Inertia Switch for safety. That includes the FCC because it will always have fuel to pump out for at least a little bit after any other pumps are killed by the switch.
Any reason to use the provided electric wires for the FCC to control the rear pump, or just run it full 12V and let it burp the pressure off in the throttle body into the return lines?
Again, depends on the load. If you are going to run both high pressure pumps through the FiTech system I would check that FiTech says it's ok to do so.
If you mean that the wires will be left over after you remove the FCC, then they would likely be good wires to re-use so you don't have to add more.
If they do indeed pulse on command from the computer to limit pressure, then I would NOT use them.
But again, I'm thinking that the 400 does not have that capability and only uses a basic pressure regulator to control what the injectors have to work with. Using a standard return line from the throttle body (of FCC) as recommended would enhance the performance of the system.
Are you currently running a return from the FCC?
Sorry if I misunderstood what you were planning. Just to be clear then, are you having trouble with the FCC? Are you planning to run just the single in-tank pump instead? Do you have, or will you be installing a return line?
Thanks
Paul