• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Fuel gauge problem

EODMike

Full Member
Joined
Mar 26, 2019
Messages
180
I recently hooked up my fuel sending unit. Brand new tank and sending unit, but replaced all wiring during rebuild, and used original gauge in instrument cluster with new regulator. When I turn ignition switch to on and when running, gauge reads full. I know for a fact it is not full.

I used the mounting posts for the sending unit as ground. Would this maybe give a bad ground and cause the gauge to read full always?

I would like to start small prior to dropping tank to check positioning of sending unit.

Thank you,
Mike
 

B RON CO

Contributor
Bronco Guru
Joined
Jun 29, 2016
Messages
2,484
Loc.
Statesville, NC
Hi, I would unplug the wire at the fuel tank sender and the gauge should go to empty. If the gauge does not return to empty there may be a short to ground along the wire or something else. Good luck
 

Jfryjfry

Sr. Member
Joined
Aug 28, 2017
Messages
503
I’ve heard (and t was true with mine) that you should verify that you’re getting the correct ohm readings at empty and full with a new tank before installing it. I did not check mine and full reads 3/4.

Basically, you need to start checking stuff. Check the ohm reading off of the tank, knowing how much gas is in it. If that’s correct, just check for continuity on the wiring between the sending unit and the gauge.
 
OP
OP
EODMike

EODMike

Full Member
Joined
Mar 26, 2019
Messages
180
I’ve heard (and t was true with mine) that you should verify that you’re getting the correct ohm readings at empty and full with a new tank before installing it. I did not check mine and full reads 3/4.

Basically, you need to start checking stuff. Check the ohm reading off of the tank, knowing how much gas is in it. If that’s correct, just check for continuity on the wiring between the sending unit and the gauge.

Thank you. I will check the Ohm readings.
 
Top