• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Fuel Pressure problem (carb), I think.

SDlivin

Sr. Member
Joined
Feb 5, 2010
Messages
793
Loc.
San Diego
So... finished replacing clutch, rebuilt TC while I was at it, then coolant leak issue so replaced heads, gaskets etc... etc.. etc...

First trip around the block, going through the gears (all 3 of them), get on it and loud pop (either backfire through carb or exhaust, not sure) and the truck dies on me. Cannot get it to start back up, acts like it wants to, just will not catch. Get towed back home. FIRST TIME!!!

Back in the garage,
Manually turn crankshaft, turns fine, so motor not siezed.
Pop valve covers off everything still looks good there and operates fine.
Pull and check dizzy, gear is fine. points etc appear okay.
Check MSD box (via their troublshoot method), appears in good order
Check spark at 1 plug, and that seems fine.

Try firing it back up and voila, it starts fine.....
Hmmm...
Check fuel pressure gauge, at '0', barely have a trickle of fuel in clear filter by tank. Carter P4070 fuel pump sounds like it is still working fine.
Replace all the fuel line with new 3/8" rubber fuel line.
From rear tank to fuel filter to Elec Fuel pump to carb, bypassing selector lever etc... for ease of diagnosing.
Still can't seem to get the fuel gauge to registor over 2psi at idle, then when I throttle it up, it drops to 0psi, but still idles.

At this rate, guessing I have a fuel pressure problem. Have never heard of the Carter pumps going south, but my plans at this point are to;
1) replace carter pump with new spare unit
2) Blow some lightly compressed are into the fuel tank sending unit (in case it is clogged) to clear that.
3) if 1 and 2 don't suffice, install a Fuel Pressure Regulator (Do these have the capacity to increase low pressure, or just regulate high pressure?)

Anything I am missing? BTW, edelbrock carb. Never had any problems before, on or off road. Did the off road springs and float adjustment awhile back.

Thanks.
 

RODRIG3911

Contributor
Bronco Guru
Joined
Jul 9, 2007
Messages
1,019
Loc.
Tucson
Did you check your fuel pump relay? Check your voltage at the pump with a multimeter. If it's good it is probably the pump or clogged filters/lines..... I had a similar thing happen to me and it ended up being that the wire from the relay to the battery came off ;D
 

Bronco Junkie

So Cal Broncos
Joined
Feb 29, 2012
Messages
3,246
Was it sitting long before you changed the clutch? Maybe just some bad gas or loose crap in the carb??
 
OP
OP
SDlivin

SDlivin

Sr. Member
Joined
Feb 5, 2010
Messages
793
Loc.
San Diego
I will check fuel pump wiring voltage. Not running a relay, just a switch between fuel pump and power. Should be 12v at pump power wire I figure.

Sat for a month or two while that work was being done.
A dirty carb would not affect the fuel pressure reading though would it?
Will spray some carb cleaner in there. Don't want to crack the carb open if I don't need to.
 
OP
OP
SDlivin

SDlivin

Sr. Member
Joined
Feb 5, 2010
Messages
793
Loc.
San Diego
Checked power to fuel pump, 12v, so that appears fine.

Started it up, fuel gauge read 5psi, perfect right?
Let it idle and watched fuel pressure slowly go to 0 in about 5 minutes.

Let engine sit for 5 min, crank her up and back to 5psi, then same as before slowly goes to 0 in a few minutes.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Do you have a filter in line before the pump? If so it may be dirty. If not there is a screwn in the carter pump it could be plugged up. Have to remove the top of the pump to clean the screen. Also might want to check the gas cap maybe its not venting properly and creating a vacuum.
 

Bronco Junkie

So Cal Broncos
Joined
Feb 29, 2012
Messages
3,246
Seems like something is getting picked up in the tank and blocking the flow and then falling back down.
 
Top