• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Gas gauge help

72EB

Jr. Member
Joined
Aug 22, 2005
Messages
133
Loc.
Hendersonville
I have checked the gauge (9V battery test) it's good, I have checked the sending unit (taken it out and checked it) it's good, but still not working...
Whats next ???

Thanks Jim
 

cbearly

Sr. Member
Joined
Jun 20, 2005
Messages
606
Loc.
Wellington, Colorado
Sounds like all thats left to check is the wires inbetween.
Have you traced the wires, or done a continuity test on them?
Are you getting any voltage where the sending unit plugs in?
 

Cooter_76

Sr. Member
Joined
May 18, 2004
Messages
863
Do you have dual tanks? If so, have you checked the tank selector switch? I recently had to bypass my switch to get my gauge working.

Good luck!
 

chuck

Bronco Guru
Joined
Aug 14, 2001
Messages
6,474
Loc.
Ingram, Texas
Does the wire feeding the instrument cluster voltage regulator have 12 volts on it? If yes does the gauge side of the regulator have a pulsing voltage on it? If yes does the wire at the tank have a pulsing voltage on it?
 

Cooter_76

Sr. Member
Joined
May 18, 2004
Messages
863
I found the orange wire from the sending unit hanging loose udner the dash. Then I unplugged the wire that ran from the switch to the back of the gauge and plugged the newfound orange wire into the back of the gauge. AND IT ACTUALLY WORKED! ;D
 
Top