• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Gear Noise

Yeller

Contributor
Bronco Guru
Joined
Mar 27, 2012
Messages
7,692
Loc.
Rogers County Oklahoma
the coast side of the gear was not worked in really well when manufactured so it looks like it has little scratches in it. Really not an issue and sometimes can contribute to noise, but most of what your seeing is a shadow in the picture. I think we've narrowed it down to a yolk issue, it fits the pinion loose and isn't tight like its suposed to be.
 
OP
OP
broncokak

broncokak

Bronco Guru
Joined
Jun 13, 2006
Messages
3,970
Steve is right, the coast side of the gears seems scratched. They are smooth if you run your finger over them tho. Drive side and both sides of the pinion gear are nice and shiny as they should be.

The sound is intermittent and happens both under power and in coast. Diving round today I'm going to add that it seems to happen with-in a certain speed range that I will try and narrow down a little tomorrow. So I'm guessing the gears are not the issue.

When I started hunting for the vibration (before the noise started) I found that the yoke on both the 9" and D20 were loose. I got new nuts, some lock tight and torqued them back down. The yoke on the 9" was not as tight on the splines as I'd like and I had planned on getting a new one. But with everything else going on I completely forgot about it. So I think it's a good place to start. I ordered a new yoke today.
 

dsg40th

Jr. Member
Joined
Nov 23, 2013
Messages
83
Loc.
Southern Maine
Looks like drive side is more worn than should be and coast side is high and a bit to the outside. I'd say pinion depth and / or pinion bearing preload could be the main culprit. It looks like you may need to take some pinion shim out of it. Of coarse when you adjust the pinion depth back lash will need readjustment as well. Motive gears are one of the worst brands for being noisy, I ran them in a Mustang GT and they were noisy and are notorius for being noisy amongst the Mustang crowds in the 8.8" rear ends.
 
OP
OP
broncokak

broncokak

Bronco Guru
Joined
Jun 13, 2006
Messages
3,970
The preload is fine but when the new yoke gets here I'll re do it. I only have one shim in the pinion now, could go thinner tho. I'd still think it would be noisy all the time if it were the gears.
 
Top