blubuckaroo
Grease Monkey
I've long been an advocate of the misunderstood "Y" steering linkage. I saw no problem with it especially when Jeep as well as other manufacturers use a similar design. I even went to the trouble and expense, a few years back, to replace the old worn out setup with a whole new "Y". One problem that has reoccured is the toe-in would change and tire wear would result. As it turns out, it takes only a little curb bumping to bend it enough to make the difference. Last weekend I replaced the whole set-up with a three way adjustable kit. I did a peliminary adjustment toe-in adjustment with duct tape, a sharpie, and a tape measure. When I took it to the alignment shop for a final alignment, they said I had it pretty close. Not bad for an ameture huh? I also replaced the pitman arm with a dropped one. This is something I should have done 25 years ago when I did the lift. This eliminated the bump steer problem I've been having after replacing the C4 with the NV3550. It would lurch a bit to the right when the nose dove during the shift. That isn't something you want happening when you have one hand on the shifter.
Anyway, I now have a greasy "Y" steering setup available if anyone still wants one... %)
Anyway, I now have a greasy "Y" steering setup available if anyone still wants one... %)











