• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Heater control cables

FORD*DIEHARD

Contributor
Sr. Member
Joined
Sep 20, 2018
Messages
353
Feels like the cables are "sticking" not smooth. Is there a way to service these cables while there Installed or do you have to remove them?

What do you recommend using on these cables to service them?

Thank you in advance for your time/help,

Sonny
 

1970 Palmer

Sr. Member
Joined
Mar 2, 2020
Messages
454
If the cable in question is a "open cable" with the set screw end, just remove and pull the cable and grease it like you would do with a speedo cable. Maybe shoot a little LPS 3 lube down the housing while the cable wire is removed.

If the cable is the "looped end" non-removeable type, you might be best to remove the assembly. Then hang it up and let the LPS 3 lube trickle down the housing while you work the cable.

The LPS 3 is a thicker/sticker "stay in place" lubricant. It does not have the awful lingering smell of some penetrating spray oils.

The cables always seem stiff, I suspect because they are not regularly used.

John
 

JSBX

Contributor
Sr. Member
Joined
Mar 10, 2010
Messages
652
I was able to free mine up while in place. They were almost completely froze up. I slipped the rings of the cables off the arms behind the dash . I then sprayed penetrating oil and worked them back and forth until they freed up. I then used the new WD 40 gel. For the cable behind the dash I just sprayed some on my fingers and reached behind the dash and rubbed it on the cables while working them in and out from the front. They work like new now. The WD 40 Gel is some great stuff. .
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Same here. My original '71 cables were very tight, to completely stuck in the case of one of them. Working them around and using WD 40 not only cured the issue initially, I only had to do it one more time over the next 25 years.
And even then, they were not really stuck or tight. Just a little tighter than they were.

I think it's the sitting, or the extra moisture of your climate that does the bad deeds. Mine came from Montana but had another owner here in CA for a couple of months before I got it, and they were stuck at only 5 years old. Very likely from moisture in MT coupled with lack of use here in CA.
Once loosened up, they worked perfectly for all those years. Now I have not used them in a long time, so next time I get a chance I'll give 'em a pull to see how they fared.

Paul
 
Top