• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

How much camber?

bigjhoov

nobody
Joined
Apr 10, 2005
Messages
3,583
I swapped a set of '76 knuckles and discs' onto the D44 on my '72. Ever since it's seemed that I've had too much positive camber in it, meaning the top of the wheel leans out. Took it the the Ford house today for an alignment reading so I can order the correct degre shims to correct it. It shows to have 1.25* of positve camber, tires leaning out. So, I check my Chilton manual and it calls for 1*min. and 2*max. positve camber, and 1.5* optimal. I would have thought it would have called for a little negative or at least 0* camber. Anyone else been through this? 1sicbronconut?
 
OP
OP
bigjhoov

bigjhoov

nobody
Joined
Apr 10, 2005
Messages
3,583
Did a search and found a little info. Apparently 1.5* positive is good for bias ply, but 0 to 1/4* negative is recommended for radials.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
That sounds about the same as the specs I looked up in the ford manual when I was checking mine. I had one side close to 3 degrees but the other was at about 1 degree. I used ball joint camber/caster adjusters to get mine as close to the minimum spec that i could.
I'm not up on all the ins and outs of camber but most of its for handling(racing/or high speed) and in our case I think its more for tire wear. You also have to keep in mind that taller tires will make that 1 degree more noticeable. I'd try to cut it in half maybe but still leave some positive camber in just for good measure.
Should be someone who has a little more insight than I do but I thought I'd give my experiance on it.
 
OP
OP
bigjhoov

bigjhoov

nobody
Joined
Apr 10, 2005
Messages
3,583
Yes, camber helps handling characteristics, especially during cornering. Idependent suspension vehicles typically run negative camber so that in a corner the tire flattens out and gives full tire contact, giving maximum traction.

And yes, I think in our case it is simply for tire wear.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
The end result though is that, in my experience, most Broncos do wear their outside edges out first. Indicating that a little less positive wouldn't be a bad thing. From a wear standpoint anyway. Not sure how it would effect the general feel, but I'd say that a little less, say 1/2 degree positive, would be a step in the right direction.

Good luck.

Paul

ps some details removed to protect the sender.
 
Last edited:

bigmuddy

Contributor
Bronco Guru
Joined
Dec 28, 2004
Messages
8,071
Loc.
Marthasville Missouri
I used the ball joint shims when I installed 79 knuckles and brakes on my 75 bronco. According to the alignment shop I have 1.5 deg camber on each side and it drives really well.

Ben
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Did you read the discussion?

I'd say so. Something I missed?
edit: like, you being part of the discussion? Ok, so I'll go back and revise my last post.
Sorry 'bout that. Can't remember all the details!!!

Paul
 
Last edited:
Top