The ones in the late '70s trucks are the hardest to find. They'll mostly likely be in the '78-'79 trucks and most frequently in the Ranger XLT trim package rigs.
'80-'86 trucks had a lot of different mounting configurations for them. The delay box may be attached with 1-2 screws on the underside of the dash (need a 7mm socket) or by a Phillips screw on the dash behind the instrument cluster. Often the wiper switch wiring is zip-tied into some of the other cluster wiring and you'll need a pair of side cutters or a pocket knife to cut the zip tie. If the truck has a hood lock handle on the underside of the dash, you may need to remove it to get to the delay box mounting screws. The hood lock handle will require an 8mm socket. A bezel tool (Nickstrix sells them) or a needle nose screwdriver will remove the locking nut on the dash that retains the switch.
The '88-'91 trucks are usually the easiest to find and easiest to push switches from. The '87 and early '88 trucks have the delay boxes mounted in such a way that they're nearly impossible to remove. You can tell the difference by a "narrow" and "wide" cutout in the plastic underdash covers. If you see a "narrow" one - go on to the next truck. You'll again need the 7mm socket to remove the screw for the delay box in the "wide" cutout next to the e-brake lever. Then look for another screw on the underside that retains the ground wire for the delay box. Use that same 7mm socket to remove the metal bracket that holds the wiper switch and headlight switch to the dash. A 5/8" socket will remove the hex nut retaining the switch to the metal bracket. Pull the switch, ground wire, delay box and associated wiring out and disconnect the assembly from the harness with a firm tug.
Todd Z.