• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Leveling Kit?

red67

Sr. Member
Joined
Sep 4, 2001
Messages
423
Loc.
Austin Texas
I have 3.5 inch Duff suspension lift, with the 11 pack rear springs. It has been over a year and a half, and the rear has not "settled" ::) yet. The rear sits a good inch or two higher than the front. Is there any kind of polyurethane spacer i kind use on the coils to achieve this? ???I dont want to have to buy new coils.
 

Skuzzlebutt

PhD, Dr. of Broncology
Joined
May 26, 2001
Messages
4,393
Loc.
Honeymoon Bay
I've seen home made things attached between the radius arms and coils but never anything for sale.
What you could do is install a pair of leaf spring shackles that are two inches longer than stock. That would lower you rear an inch.
 

broncobsession

Bronco Guru
Joined
Aug 12, 2001
Messages
4,049

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
the rear shackle idea is good but I dont think it will work for you unless you have a body lify to clear it check out sierra bronco web site they have something that may help you out called coil shims for about $70 although I think it will end up costing you a bit more you may need new bushings due to more lift. maybe your front springs have settled new fronts maybe cheaper than your other options
http://sierrabronco.com/
 

Skuzzlebutt

PhD, Dr. of Broncology
Joined
May 26, 2001
Messages
4,393
Loc.
Honeymoon Bay
Also, what alot of cheap ass people will do is add these little 1" blocks in between a few of the coils on each spring 'till they get the ride height they want. These this are only held in place by spring tension. The first time you get full extension of a coil, these pieces will fall out. :p
The springs are ugly when these are in place, :mad:and even uglier after they fall out.
 

swood

Sr. Member
Joined
Mar 13, 2002
Messages
639
Loc.
San Jose, CA
This does not sound good. I have a duff 3.5 inch suspension, however the body and so on is not back on yet. Is this typical for the rear end to sit high on all duff suspensions?
 

whtawreck

New Member
Joined
Feb 6, 2003
Messages
8
Loc.
Camarillo, CA
Just installed 3.5 Duff and have same situation and the engine isn't in yet. I'm thinking of putting 1" aluminum spacers under the front coils. I haven't measured it out yet but did this on my Rov** and it came out great and under $20.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
I have the opposite problem. My rear end is sagging. I have a heavy rear bumper and the 10 leaf springs.
You could try pulling a leaf out of the spring pack and see how much it settles down. Maybe make a huge heavy bumper?

If you drop it an inch, could you send me the 11th leaf, I could realy use it ;)
 
Top