• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Locker: Front or Rear?

Panama71

Sr. Member
Joined
Nov 24, 2002
Messages
356
Loc.
Albuquerque, NM
This is from Aussie Lockers website:

Q6. If only installing one locker should I install in the front or rear?

A.
This is dependent on your personal preference, the type of vehicle, existing diff types, and how you intend to use the vehicle.

a. If a vehicle has an IFS (Independent Front Suspension) system then the front installation will result in a dramatic increase in 4WD capability. This is because all IFS vehicles have very limited suspension movement (wheel travel and articulation) resulting in easily lifted wheels and a loss of front traction. Installing a front locker will solve the deficiency.
b. If a vehicle has LSD (Limited Slip Differential) in the rear, then a front installation provides a significant improvement over the existing LSD and open diff set-up.
c. If a vehicle has constant 4WD then only a rear installation should be considered.
d. A front installation will usually yield the greatest improvement in off-road capability. This is due to the general requirement of increased in traction under hill climbing or rock crawling. Under full climbing conditions, due to the angle of the vehicle, the rear wheels carry a much greater weight (weight transfer) and therefore, the front carries less weight and tends to break traction very easily. Once one front wheel starts to spin the other wheel stops turning and the whole front diff ceases to provide traction. At this point the load is transferred to the rear diff as if the vehicle was a 2WD and due to the increased load the rear wheels tend to spin and the vehicle stops. If you can stop the front wheel from spinning you have solved the traction problem. In addition to the traction performance a front installation does not introduce any changes in handling characteristics


Also, I checked and there were no entries for the 9 inch.

Checked on the Eaton Electric and they only make that for the 8.8.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
I have been very inpressed when driving with just the rear locker. I could run stuff that I couldn't think about in 4WD with open diffs, or even open/posi.

The loss of turning ability in the front is the biggest problem up there. I would like to replace the lock-rite with a selectable in the front someday. Some say just drive with the drivers side hub unlocked and get out and lock it in when you need it. What a pain! Rear locker is great.
 

thedirtyneck

Jr. Member
Joined
Jun 29, 2003
Messages
89
Loc.
Blacksburg/Charlotts
I always thought that if you were going to have a locker in the front then its really not a big deal to have a selectable over an auto locker. When you have a hub unlocked it behaves like an open diff. So that when you are on the road your not going to have turning problems. I dont know many people who drive on the road with their front hubs locked. I do think the electrac woudl be excellent up front because with the hubs unlocked its an open diff, with them locked its a L/S and with the locker engaged its fully locked. Add a selectable rear and a twin stick and you can have all kinds of possibilities to play with.

I e-mailed aussie about the 9" and they said sometime this summer it should be out.

Anyone used Auburn gear lockers?

Brian
 
Last edited:

Skuzzlebutt

PhD, Dr. of Broncology
Joined
May 26, 2001
Messages
4,393
Loc.
Honeymoon Bay
With one hub unlocked, a locker will not behave like an open diff. If it did, the open differential would never have been invented. They would just use a spool with only one axle connected to it.

Lockers in the front are fine on the rocks or if you only wheel in straight lines. Your steering will be very affected when on loose/slippery surfaces or on side hills.
 
Top