Ok, need some help here guys. My manual shift collar has been broken for years. PO had it held together with hose clamp. I have had the replacement part laying in the garage for a couple of years and thought I'd finally replace it today however I cannot get the new one seated all the way. Seems like it needs to go down about another 1/4" to fit into the slot at the top of the column.
I am not seeing any movement in the engine compartment. How do you make the steering tube engage the shift levers? The tube came "out" about 1 foot when pulling the collar.
I am not seeing any movement in the engine compartment. How do you make the steering tube engage the shift levers? The tube came "out" about 1 foot when pulling the collar.












