• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Replacing front hinge posts

Madgyver

Bronco Madman
Joined
Jul 30, 2001
Messages
15,030
How do you get the exact placement when doing a remove and replace of the front door hinge post?

thumb_doorpillarspaircopy.jpg


I'm also replacing the cowl section below the windsheild hinge mount. The existing cowl is too messed up to be used for reference points.
 

Felipe

Full Member
Joined
Feb 6, 2008
Messages
194
Loc.
Concord, NC
Measure everywhere, point to point, front to back side to side, those post n the pics look like the ones from tom's. I got one from them and on the inside of the post, the brace for the hinge plates was not welded to the back side of the post . That was making the post wider then it was supposed to be so I welded it and it brought it to where it should be;Probly also helped the door not sag because there was nothing for the brace to attach to. Also had to trim off the top, and bend the tab that is welded to the bottom of the cowl down 1/4 inch so it would sit under the cowl at the right height. I measured off the floor to the top fender bolt hole.wow, sorry for the long story hope it helps. also make sure everything is sitting level then take all the measurements.I also put in a brace from the trans. tunnel to the underside of the cowl to hold it up
 

thesnake

Bronco Guru
Joined
Jun 20, 2001
Messages
3,503
Maybe this will help.

John
 

Attachments

  • doormeasurements.jpg
    doormeasurements.jpg
    79.7 KB · Views: 111
OP
OP
Madgyver

Madgyver

Bronco Madman
Joined
Jul 30, 2001
Messages
15,030
snake,
thanks, I have that pic saved on my hardrive. I'm more concerned about the side to side measurements since my cowl will be out at the same time.
I'm thinking of fabricating a jig to mount to the hinge bolt holes and welded to floor, tunnel, and sticker post. I can then remove the hinge post by cutting and unbolting and bolt back on the new part to mock up. After the final checks are done I can tack it in place.
 
Top