• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Right Blinker goes soild when I apply Breaks

Fathom

Bronco Guru
Joined
May 6, 2004
Messages
1,171
Loc.
Los Angeles
Any idea why my 'Right' blinker works fine until I hit my brakes, then it goes solid.

My left works normally.

All of my bulbs are good.

I did swap out my column recently, but I thought it was working correctly when I was done.

THANKS

I hate ripping out the seat so I can fit under the dash.....

Brian
 

RajinCajun

Bronco Guru
Joined
Nov 22, 2003
Messages
1,587
Loc.
HawleyTX, La orig.
Your blinker fluid is about a quart low :)

Bet you have a short or it is wired wrong.. Does it have a trailer plug? If so check that area of the wiring too.. I have seen lots that were thrown together in a hurry and not done very well at all...
 

bigben128

New Member
Joined
Sep 15, 2008
Messages
3
Sounds like a bad ground to me...Same thig happened on my Old Mustang. Turned out the housing was missing a screw. I replaced it and it worked fine. Good luck!
 
OP
OP
Fathom

Fathom

Bronco Guru
Joined
May 6, 2004
Messages
1,171
Loc.
Los Angeles
Sounds like a bad ground to me...Same thig happened on my Old Mustang. Turned out the housing was missing a screw. I replaced it and it worked fine. Good luck!

Now that is a good idea to check. THANKS!

I think my dipstick broke off in my bulb fluid reservoir, I can't check the level:cry:

Hmmmm, I'll check the plug.....thxs

Brian
 

hose101

Full Member
Joined
Jan 30, 2006
Messages
272
just pump the brakes when you want to turn right. problem solved... I think;D ;D ;D
 
OP
OP
Fathom

Fathom

Bronco Guru
Joined
May 6, 2004
Messages
1,171
Loc.
Los Angeles
Found IT!

I had recently installed a new column and did not realize I had a problem.

The PO must of had an electrical problem and decided to add in his own wires.

He tapped into the right blinker that feeds the column instead of after the switch. Plus he added a second lamp in the tail light that was fed off the wire he tapped.

66 broncos only have 1 light bulb in each tailight, so that was easy to spot.

So once I put the wiring back to stock (Thanks to seabiscut's colored diagram), it WORKS!

THANKS everyone......

Brian
 

Attachments

  • 66-67exterior-color_1.jpg
    66-67exterior-color_1.jpg
    162.5 KB · Views: 54
Top