@jamesroney check out the last two photos in the original post. There's a part number listed for your passenger seat latch you're looking for (or one similar to it)
Hey
@thegreatjustino Thanks a TON. I found item 11, the C7TB-96619A86-A Latch Assembly, Passenger seat. Great to know. Now just need to find one!
As far as the seat shoulder bolt goes,
@DirtDonk and
@jerry you have missed the point. Those seat bolts are designed to retain the seat in the event of a collision. There are three locations where that special 5/16-18 shoulder bolt with a 5/8 hex head are used. I have removed many originals, and they are prone to twisting off at the thread base. The bolts are designed to provide a secure connection to the seat riser, AND the oversized hex head is designed to provide additional tear out resistance against the lower hat channel reinforcement bar.
It would have been easy for Ford to install a nut plate in that location, but they apparently wanted the additional strength of the structural member (hat channel) to support the seat to prevent pull thru. So the shoulder near the threads sandwiches the floorpan, and the shoulder near the hex head sandwiches the hat channel.
This is a safety device, and it should not be neglected. There is NO regular bolt that can serve the same purpose. I started boring my old broken one's out and threading and inserting a dog-point stud into the old bolts. No matter how many I make, it seems that people want them. You can get away with using a long flange head bolt with a spacer. I've also put the bolt in from the top, and added the spacer on below and then tightened with a flange nut.
The old bolts usually get stuck on undercoating and fall out sometime after seat removal, and before paint. Most of mine are out on the interstate somewhere, or perhaps in your tire.
I've thrown away more than my fair share...always wondering who put that oddball shoulder bolt under my Bronco. I think Nick had some repop'd for like $40 each. Or maybe $40 a set.