• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Small six questions

Braddw25

Full Member
Joined
Jan 23, 2009
Messages
287
Loc.
Jersey Shore, PA
Hi everybody,

I asked a months ago about the small six in my bronco. From the responses I got and the book I ordered from classicinlines, I thought that I had determined that my engine was a 170 based on the number on the side of the block. The strange part is that my block has 5 frost plugs and I thought that 170's only had 3. Also, I just read earlier today that most 170s do not have the oil dipstick in the block. My engine does have the dipstick in the block. It also has a dipstick in the oil pan too so which could just be there because a P.O. swapped the original rear sump oil pan from a 170 onto this block which is either a 200 or a 170. Does anyone have any idea how I can determine for sure what I have? Thanks!
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,110
I always refer these questions to www.fordsix.com
I remember the Bronco 170 is a little bit of a bastard engine. 7 main bearings instead of 4 or some other wierdness that doesn't follow typical car engine lines.
 

Explorer

Bronco Guru
Joined
Mar 2, 2008
Messages
4,390
Loc.
Raphine, Virginia
Definatly visit FordSix. The 200 came in 73/74 Bronco's. The 200 has 5 plugs and seven mains. After all these years anything is possible as the Mustang's came with a 200ci. My 66 has a 200. There were 7 main 170's but rare. The intake/head has a casting number and the 200 head fits the 170. I think you could measure the stroke thru a spark plug hole, the 170 is 2.94 and the 200 is longer at 3.126. Never did that, but sounds feasible. Someone will correct me.
 
Top