• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Starter dragging explorer motor??

doghows72

Bronco Guru
Joined
Jan 5, 2005
Messages
2,036
So for the last week or so my starter has been dragging, kinda like the battery is going dead.
So far I have swapped out the starter, new selenoid, cleaned battery terminals, cleaned and checked all cables and ends.
I put my jump box onto the battery terminals and it still drags like there isn't enough power to crank it. Battery voltage with engine off is 12.4, with engine on it 14.6. Unfortunately I do not have a good way to test the amp draw because I'm by myself out there, that was the reason for the jump box. I figured it would give it the juice needed?
I'm open to ideas. The engine is a 97 explorer and I did keep the DIS system. It almost sounds like an engine trying to start with the timing to far advanced.
It will start up and run every time but it wasn't doing this last week.
Thanks guys.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Wow. Every time there's an issue with an EB, it seems like instead of it being straightforward and simple, it's completely unusual and oddball.

I say that because you're right about the ignition timing. With all the new stuff you've already thrown at it, you would think timing would be the last thing left. But with the DIS setup, I'm not sure how that's possible.
Maybe check with EFIGuy to see if there is a circuit in the computer that will advance the timing too far if it fails.

Other than that, there could be a physical problem such as the bell housing bolts or torque-converter bolts coming loose I suppose. Not unheard of in either case, but not sure that either would give you the hard turning symptoms.

Does it happen all the time, or just when it's hot or cold, or other circumstances?

Paul
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Any of the battery cables older? Even if they're clean and look good, they can fail.
Usually it lets you know immediately when the power is killed, but I could easily see one failing slowly and not being able to conduct all the current needed to spin a starter.

Good luck. It's an odd one for sure.

Paul
 

surfer-b

Contributor
Bronco Guru
Joined
Sep 7, 2006
Messages
3,013
Just to be sure run a heavy grnd wire straight from batt to one of the starter bolts, see if this does anything, if so then you have found your problem
 
OP
OP
doghows72

doghows72

Bronco Guru
Joined
Jan 5, 2005
Messages
2,036
As usual you guys are awesome. Went back out to double check everything and low and behold the ground cable from the battery to the block didn't seem up to par.
So I pulled it off, cleaned stuff up and viola!! She cranks like a new starter again. Just goes to show how important grounds are.
Lesson: GROUNDS, GROUNDS, GROUNDS can't say it enough.

By the way this problem only took about a year since this engine was installed to occur so you never know! Thanks guys!
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Yep, you have to think broadly with these things!
I've always kept my battery cables in pretty good shape. Get a good lifetime out of them, but end up replacing them probably sooner than most would.
Once had a pretty expensive nicely made positive cable to the starter relay that gave me fits. Took me about six months (or probably more!) to figure out that my barely 2-year old cable had failed internally.
Still looked brand new, but every once in awhile (hate those intermittent failures!) I would turn the key, get a quick click of the starter relay, then all power through the whole truck would die. Nothing. Nada.

I kept thinking it must be something elsewhere, but nope. Was the almost new cable.
New cheap one and problem solved.

Glad you got your crank back!;D Starter mojo.

Paul
 
Top