• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Stuck Gas Cap

CrazyHorse72

Full Member
Joined
Oct 5, 2003
Messages
235
Loc.
Pennsville, N.J.
Has anyone ever had to get a locking gas cap off without a key. The key that came with my Bronco is either wrong or to worn out to work.

Any suggestions?
 

mustangmarty

Bronco Guru
Joined
Apr 1, 2003
Messages
1,229
On my 76 E-150, my brother got a couple small sharp knives and slipped each one up under the gas cap and wiggle them both against the spring loaded latches until they both were pushed back into the cap far enough for the cap to slide off the filler tube.

You might also try to pick the lock. They are pretty simple, and cheap to replace if (when) you bugger it up.

Good luck.
 

mtkawboy

Bronco Guru
Joined
Jan 28, 2004
Messages
1,525
Loc.
Billings Mt
If all else fails a body shop slide hammer for pulling out dents will permanently remove the key part, but will ruin the cap
 
OP
OP
CrazyHorse72

CrazyHorse72

Full Member
Joined
Oct 5, 2003
Messages
235
Loc.
Pennsville, N.J.
I don't care about the cap, I just want it off.

I was thinking of drilling out the keyhole, but wasn't sure if that would work. Never done this before.

Thanks for the input!
 

ken75ranger

Bronco Guru
Joined
Jan 27, 2002
Messages
5,069
Loc.
Troy, NY
CrazyHorse72 said:
I don't care about the cap, I just want it off.

I was thinking of drilling out the keyhole, but wasn't sure if that would work. Never done this before.
Probably not a good idea. Hot metal shaving and gas.%)
 

Moaiz

Full Member
Joined
Sep 5, 2002
Messages
340
Loc.
Albuquerque, NM
I got my 77 with a locking cap but never got the key. I worked on it with two screwdrivers, a prybar and it came off in about 45 minutes. I would veto the idea of drilling it.
 

mustangmarty

Bronco Guru
Joined
Apr 1, 2003
Messages
1,229
CrazyHorse72 said:
I don't care about the cap, I just want it off.

I was thinking of drilling out the keyhole, but wasn't sure if that would work. Never done this before.

Thanks for the input!

Even if you were careful and it didn't go "boom," you'd still more thn likely end up with a few metal shavings in the bottom of your gas tank, which may be okay until it finds the outlet line to the fuel pump.
 

brewdude

Bronco Guru
Joined
Jun 12, 2002
Messages
1,571
Loc.
Groveland, CA
I had to do this last week. I just pryed it off with some screwdrivers. If it was like mine, if you take the metallic sticker with the writing on it off. You will find 4 tabs that hold the out side of the cap to the main piece. If you pry on it enough they will brake through the cap piece from there just use the screw drivers to push in the tabs that hold the main part of the cap to the filler hose. Just be carefull not to push that piece into the tank.
 
OP
OP
CrazyHorse72

CrazyHorse72

Full Member
Joined
Oct 5, 2003
Messages
235
Loc.
Pennsville, N.J.
Thanks Again Guys!

I was planning to remove the filler hose before doing anything destructive anyway.

And its definately time for some destructive behavior!
 
Top