• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Swerving

MikeCon

Full Member
Joined
Apr 7, 2019
Messages
276
I know I've asked this before but maybe there's some new ideas.
When making a long left turn around 50 or 60 bronco tracks smoothly but before corner ends it swerves left. Then settles down and is fine again. Almost always left only.
Any ideas? Everything seems tight.
 

MarsChariot

Contributor
Planetary Offroader
Joined
Oct 12, 2004
Messages
2,605
Loc.
Albuquerque, New Mexico
I would start by checking the leaf packs on the rear; maybe a bushing or bolt. Then move forward. It sounds as though something is fine until it sees the side loading under those conditions, snaps into a new stable set and is then o.k. and stable.
 

Speedrdr

Contributor
Legend in my own mind
Joined
Nov 27, 2017
Messages
2,028
Loc.
Paris, MS
A few questions for you. Does it have suspension lift? If lifted, were the C-bushings changed? If changed, are they the appropriate degree for the lift and installed correctlyÂ…I found out the hard way there IS a right and wrong orientation.
On my 1st EB it handled pretty much like you described as well as with the awful darting in odd directions under braking. Getting the C-bushings replaced and oriented corrected the wandering. Hope this helps you in some way to figure out your issues.

Randy
 
OP
OP
MikeCon

MikeCon

Full Member
Joined
Apr 7, 2019
Messages
276
Thanks guys. Been thinking of replacing springs anyway. When I stop rear makes single clunk and lifts slightly. Then when I take off I get single clunk and rear settles.
I'm thinking rear springs and associated parts.
May all be related.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Is it where you lift off the throttle or touch the brake?
Do you have a mechanical locker in the rear axle?

When I was running a Detroit locker there was a noticeable bump from the rear as the engine torque shifted between positive and negative (engine driving the axle and the axle driving the engine)
 
OP
OP
MikeCon

MikeCon

Full Member
Joined
Apr 7, 2019
Messages
276
All stock. Accelerater has no effect. Clunk and movement in rear is when truck comes to full stop and when it starts moving again.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
A sticky driveshaft slip joint can do the same thing as well regarding the clunk. Would not have any effect on your steering characteristics usually though.

Are there previous discussions where you have already added all the details Mike?
Things that can affect steering in ways similar to what you describe, if not exactly, could be slight variations in tire size, slight variations in tire pressure, improper toe-in settings, a slight lift kit without installing dropped Pitman Arm and track bar bracket. Tire age and condition is very important to this equation.

As mentioned, a locker or a particularly aggressive limited slip can create this issue as well. Although they're more likely to rear their ugly heads when you press on the accelerator and let off. But dying rear wheel bearings, improperly adjusted or serviced front bearings, flex while cornering affecting Disc brake tensions, worn out ball joints or steering axle u joints are all things to look into.
And then there is the steering box itself.

What of all of those items have you serviced, replaced, upgraded, modified, or closely inspected?
 
Top