• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Synchro gear roll pin breaking

BoulderBronco22

Full Member
Joined
Oct 1, 2012
Messages
234
So I have a flat tappet cam on my 351 that I've converted to EFI using the cam synchro shaft and sensor from an early 2000's 3.2L F150. I have changed the gear from the steel gear to an iron gear so that it will be compatible with my iron cam. I have used a new synchro shaft from the parts store each time and each time, I can press the gear onto the shaft by hand. The OEM part requires a shop press or a big hammer to get the gear off meaning it shouldn't be that easy to take the gears off and back on on the re-man Chinese junk.

For the 3rd time, the roll pin that holds it in place has broken and I lose all oil pressure. I'm not using a high volume oil pump. I feel my best solution would be to get an OEM from a junkyard and swap the iron gear on that so there is less stress and pressure on the roll pin.

Has anyone else had this issue and found a solution? Any other ideas or suggestions on how to solve this?
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Hopefully someone will know for sure, but so far there aren't that many people using the combination of parts you have, so you might have to hang in there for awhile yet.

But I would say that it's the gear fit entirely. Without a press fit, the pin is the sole locator of things. And it's just not capable of all that, as you've already found out.
At least with a tighter press fit, the pin is only a backup. And frankly, the quality of the pins these days is probably questionable too, along with the other parts. As you were already thinking.

Good luck. And back to the top for others to see again.

Paul
 
OP
OP
BoulderBronco22

BoulderBronco22

Full Member
Joined
Oct 1, 2012
Messages
234
Thanks for weighing in Paul. I hit the JY today and grabbed the synchro from a 2001 F150 with the 4.2L engine. The OEM was a very tight press fit so I'm hoping that holds up.

Long term, I intend to convert to a roller cam so I can just run a stock synchro gear and hope I won't have to worry about this happening again.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
I think the loose fit is the problem as well. My solution is a bit bastardly, but I would braze the gear to the shaft (maybe silver solder). Throw it away when you go roller cam.

The gear should be a press fit. Pin only keeps it from moving. With a loose fit the pin is now taking a driving force and not just locating.
 

nvrstuk

Contributor
Just a Bronco driver for over 50 yrs!
Joined
Jul 31, 2001
Messages
10,622
Loc.
PNW
Agreed with all suggestions above. Here's something you might also check for longevity. Check the clearance between the bottom of the drive gear and the block mating surface.

When I was switching, adapting and mating EDIS 3.8 sensors to my 5.8 stroker motor block I had all kinds of issues with proper fit, melonizing on some and not other's, etc. Couldn't believe the inconsistencies in production.

You'd think Ford engineers would take some pride some day... nothing interchanges...


Good luck...
 
Top