Bronco Junkie
So Cal Broncos
- Joined
- Feb 29, 2012
- Messages
- 3,246
Always wear safety glasses when someone is welding on the inside and you are underneath holding the dolly.
When using a cut off wheel watch where the sparks are going they will set something on fire!
Not mine, but I was helping...make sure the torque converter is fully seated prior to transmission installation and engine start-up or you'll lose the tabs on the front of the pump.
Not mine, but I was helping...make sure the torque converter is fully seated prior to transmission installation and engine start-up or you'll lose the tabs on the front of the pump.
Did this myself, but thankfully engine would not crank, so no damage and I was able to put the torque converter all the way on.
I've owned my Bronco for 17 years (plus I'm getting old) so I'm hardly a newbie!
Should someone start a new thread "Tech Lessons (Veteran Mistakes)"? I may be able to make a contribution or two...:-X






