ntsqd;2646010
As to the "too much heat for sheet metal" statement said:
Please reread my post. Nowhere did I mention blowing through. The OP mentioned this about his GMAW welding. I talked about heat input and the resultant warping from shrinkage.
In GMAW welding when you pull the trigger the wire initiates and the arc starts. Most of the heat from the arc goes to melting the wire. When you release the trigger, the wire stops feeding and the arc stops. In the garage you are most likely using the short circuit transfer mode, the coolest of the three GMAW transfer modes. Basically this means the wire actually touches the base metal, shorts out, heats up, and explodes, then does it again, ect, ect, ect. This is what causes the "frying bacon" sound you hear.
In GTAW you light off on the piece by pushing down on your control pedal or pushing the decay button (ignoring scratch start here), wait for the arc to stabilize, then ramp up your arc to build the weld puddle. When the puddle is the size you want you can then begin adding wire and moving along the joint. As human beings, we are not as efficient at consistently adding the wire at the correct rate as the machine is. This means you naturally move along the joint at a slower rate than you would with an semi-automatic machine. If the wire you are trying to melt into the puddle is larger in diameter than the thickness of the base material (remember we are welding thin guage body sheet metal here) you are going to have a rough time at it. When you are done with the bead you then stop adding wire and slowly ramp your arc off. In starting the arc, moving along the joint, and stopping the arc you have added extra heat to the base metal with GTAW that GMAW would not have.
The heat added while welding both melts the base metal and causes expansion along the weld joint. As the weld joint cools it contracts more than it expanded causing distortion that we see as warping. The more heat that is put into the base metal the worse the warping. When using GTAW over GMAW you are adding extra heat to the base metal in the arc start, slower travel speed, and extinguishing the arc. This extra heat means more warping.
Can GTAW be used to weld sheet metal? Of course it can. Is it the best choice to use to get the best possible results? No it isn't. For welding sheet metal stick with your GMAW machine. If performing lap joints, keep your stringers short and skip around a lot. If you are plug welding, put a backing bar behind the joint to support the puddle and act as a heat sink. If you are using a butt joint, make your weld a series of tacks, moving around the joint to keep it cool and distribute the distortion until you have a completed weld.