Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.
This is where all the old posts go so they can still be used for reference and searched.
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
If you have problems registering or can't log into your account, please contact Admin.
I AM REBUILDING MY TRANSFER CASE.I NEED.I TO KNOW THE PLACEMENT OF THE 13 BEARINGS IN THE REAR OUTPUT SHAFT.THERE APPEARS TO BE A LIP IN THE SHAFT,IF I PUT THE BEARINGS BELOW THE LIP THEY ARE TOO TIGHT ABOVE TOO LOOSE.
I recently did the same job. My thirteen rollers were placed as far into the bore as possible. I did take some jigling for them to fall into place. Do slather the area with some grease so that when in place, the rollers do not fall out. Good luck. lodnigs