US Shift Quick 1 O/D On/Off

[77broncodriver]

I am wiring up a switch to my transmission controller and running into a problem. I have confirmed I have 12v power to the dark brown wire at the controller when the switch is pressed in but it still shifts into 4th.

Is there any thing I need enable tuning wise or on the controller before this feature will work?

 

[Broncobowsher]

I thought you grounded the wire? Not apply 12V to it. But it has been many years since I wired up the last few. And I never got that generation of controller either.

 

[spap]

Aren’t you activating the circuit by pressing the switch in
Shouldn’t shift into OD if open but I will have to look at mine again.
My switch a is a toggle but have a light with it starts out with of on and I have to turn it off so it doesn’t it go into overdrive

 

[mgb0302]

Broncobowsher is correct. For the switch to work, it needs to be grounded. It can be either momentary switch or a locking on/ off switch (just choose the proper option in the computer set-up screen).

 

[77broncodriver]

Here is the diagram I was going off of. This means that when the button is engaged the #4 pin should have 12v power right?

I am also going to make sure the setting is correct on the software

 

[JSmall]

Have you configured it in the System Settings?

 

[JSmall]

This is how I have mine wired and it works perfectly.

 

[77broncodriver]

This is how I have mine wired and it works perfectly.

I am pretty sure this is how I wired mine so I must just need to go into the settings and make sure it is set to the right switch option.