RG801
Jr. Member
Alright, I'm stoked about this so I have to post. This topic has been brought up many times on this forum, but it never hurts to overstate common fixes.
Story:
'72 - 302 - 3 speed manual
Bronco was stumbling/almost dying on acceleration. It idled fine, but as soon as I stepped on the accelerator, it would cut out. With a little extra push on the gas and some serious clutch feathering, I could get it to go. Typical vacuum leak symptoms.
I've been chasing this problem in my spare time for a while. I sprayed carb cleaner around vacuum connections and couldn't really detect anything. Also changed the PCV. Then I changed fuel filters...no luck. Fuel pump is new, so I ruled that out. Goofed with the carb and timing...nothing. Changed spark plugs...fail. I couldn't find anyone in town that stocked Mallory caps/rotors, so I cleaned the contacts with an emery cloth...still nothing.
Tonight I decided that it had to be a vacuum leak. I started changing every hose/cap and re-taping threads on manifold ports. I then noticed a little oily film around the vacuum port on my Performer intake. The PO had installed a multi-port connection there. When I pulled it out I was surprised to find that is was a little loose and the threads were bare...no tape or thread sealer. I swapped the multi-port out for a plug (with tape) and BINGO...the Bronco's running great. No more stumble!
Anyway, that's my story. Hopefully my experience can help someone fix a similar problem in the future.
Story:
'72 - 302 - 3 speed manual
Bronco was stumbling/almost dying on acceleration. It idled fine, but as soon as I stepped on the accelerator, it would cut out. With a little extra push on the gas and some serious clutch feathering, I could get it to go. Typical vacuum leak symptoms.
I've been chasing this problem in my spare time for a while. I sprayed carb cleaner around vacuum connections and couldn't really detect anything. Also changed the PCV. Then I changed fuel filters...no luck. Fuel pump is new, so I ruled that out. Goofed with the carb and timing...nothing. Changed spark plugs...fail. I couldn't find anyone in town that stocked Mallory caps/rotors, so I cleaned the contacts with an emery cloth...still nothing.
Tonight I decided that it had to be a vacuum leak. I started changing every hose/cap and re-taping threads on manifold ports. I then noticed a little oily film around the vacuum port on my Performer intake. The PO had installed a multi-port connection there. When I pulled it out I was surprised to find that is was a little loose and the threads were bare...no tape or thread sealer. I swapped the multi-port out for a plug (with tape) and BINGO...the Bronco's running great. No more stumble!
Anyway, that's my story. Hopefully my experience can help someone fix a similar problem in the future.











