• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Warn premium hub locking issues issues

WDGS

Jr. Member
Joined
Aug 23, 2011
Messages
134
I thought these things would be the easiest part of my axle swap. I had a lot of trouble getting the retaining rings in the groove - i had to apply a lot of force to the u-joint area in order to get the ring in.

Once I got that solved, now I find the hub caps to be very hard to turn. I understand that that is normal with he premiums but the issue is while the drivers side locks in a 180 turn, the passenger side takes about a full turn to lock and when I unlock it it doesn't want to disengage from the axle shaft..

What did I do wrong?
 

Pops68

Contributor
Bronco Rookie
Joined
Oct 11, 2010
Messages
1,777
Loc.
Bazetta Township
Do you have the correct model hubs to match your axle/vehicle/year??

I haven't installed mine yet, but I have a Dana 30 and needed the correct model hubs to work.

Just a thought.

Pops
 
OP
OP
W

WDGS

Jr. Member
Joined
Aug 23, 2011
Messages
134
Dana44 - warn premiums 20990. Pretty positive they are the right model
 

73azbronco

Contributor
Bronco Guru
Joined
Nov 11, 2007
Messages
8,782
Might want to recheck what you installed and how and I mean is the hub tube, the part you install the parts, out of round? You mentioned axle swap, are the axles the right length? I had a set which were not once, took me weeks to figure it out.
 

75junebug

Sr. Member
Joined
Jan 10, 2008
Messages
587
Loc.
NW Houston Tx
If I remember right, when you install the outer cover with the selector, the selector has to be in the locked position. If its in the free position, it can be difficult to turn and not engage.
 

joshnjulie1

Sr. Member
Joined
Jul 11, 2012
Messages
891
Loc.
Moreno Valley, Ca
I just installed these about a week ago. They should be installed in the free position according to the directions. It was a very easy install when putting in the outer clip ring/etc. these hubs take almost a complete rotation to lock/unlock. As with most things, I woul dimagine them to loosen up a hair with wear but it sound like there may be something wrong. When turning mine, they are not easy to turn but not hard. I believe them to be just tough enough.
 

Jdgephar

Bronco Guru
Joined
Sep 25, 2012
Messages
1,526
Did I miss something? Warn lists the same part for the Dana 30 and 44 Broncos, and I used the same ones on both the 30 and 44. Are the lock nuts and bearings all seated and installed properly?
 
Top