I have my driver floorpan pretty well trimmed and fitted. At the kick panel, there is a 1/4" or so gap. I did not trim this straight edge of the new pan at all. This edge lines up pretty darn well with the overlapping flap on the flat part of the floor, but the gap at the kick panel bugs me.
Am I supposed to T weld the patch to the kick panel? Lap weld a piece underneath? Don't weld there at all and use seam sealer to seal the gap? Some combination of the above?
This is my first time doing this. I'm comfortable with the spot welds at the floor support and rocker edge flap and the butt welds everywhere else. It's just this gap at the quarter panel I'm questioning.
Am I supposed to T weld the patch to the kick panel? Lap weld a piece underneath? Don't weld there at all and use seam sealer to seal the gap? Some combination of the above?
This is my first time doing this. I'm comfortable with the spot welds at the floor support and rocker edge flap and the butt welds everywhere else. It's just this gap at the quarter panel I'm questioning.











