Years ago (early 2014) I picked up at windshield lower frame seal from Wild Horses (it's the Dennis Carpenter part).
I'm guessing that the "bead" part sits furthest from the hinge (see pic below). What I'm curious about is how the hole for the wiper wiring is sealed.
One way would be to remove the wiring (which sounds horrible), punch a hole in the new seal, and reinstall with weatherstripping adhesive. I've also thought about cutting the new seal into two pieces (I have 3-4 inches extra which is nice), putting 1/2 a hole in the end of each, and reinstall with the adhesive.
My plan is to set this up so the windshield can be lowered when needed. Advice is much appreciated, thank you for your help.
I'm guessing that the "bead" part sits furthest from the hinge (see pic below). What I'm curious about is how the hole for the wiper wiring is sealed.
One way would be to remove the wiring (which sounds horrible), punch a hole in the new seal, and reinstall with weatherstripping adhesive. I've also thought about cutting the new seal into two pieces (I have 3-4 inches extra which is nice), putting 1/2 a hole in the end of each, and reinstall with the adhesive.
My plan is to set this up so the windshield can be lowered when needed. Advice is much appreciated, thank you for your help.











